Eachine Racer 250 Archives

LibrePilot PID used in video Eachine Racer 250: the little FPV airgate

Here are the PID used in video Eachine Racer 250: the little FPV airgate... Continua »

PID used in video Eachine Racer 250: Circle Air Gate – Fpv Racing

Here are the PID used in video Eachine Racer 250: Circle Air Gate – Fpv Racing Quadcopter: Eachine Racer 250... Continua »

Multifunction More Than One Light Control Low Voltage/Runaway/Missing Alarm Board For FVP Racing Multicopter

Review Under construction…. Video buy one here ... Continua »

Eachine Racer 250 : EasyTune PID used in video “TWO Eachine Racer 250 for ONE Air Gate”

Here are the PID I used in the video. I calculate them with EasyTune in LibrePilot. TWO Eachine Racer 250... Continua »

Ho to mount GoPro on Eachine Racer 250

In this photos I show how I monted the Gopro on my Eachine Racer 250. With a little angle up... Continua »

Come impostare la Turnigy 9X per CC3D Flight Control

Per impostare correttamente la radio Turnigy 9X con il flight controller per multirotori CC3D dobbiamo seguire questi passi: collegare il... Continua »

Eachine Racer 250. Pid used in video “under the canopy of trees”

I’m testing the Easytune function of LibrePilot. In this video I’m checking some changes on the YAW’s PID. The video... Continua »

How to break and replace arms on Eachine Racer 250

Sometimes you can broke arms on your FPV Multirotor Eachine Racer 250. See my video to see how to break... Continua »

Eachine Racer 250 : Pid used in video “race into trees”

One day with friends into trees.. And this is the pid used. I reduced I in Pitch and Roll…but... Continua »

LibrePilot a new firmware for FPV Multiror Racer (ENG)

For italian versione go here The LibrePilot open source project was founded in July 2015. It focuses on research and... Continua »

LibrePilot un nuovo firmware per FPV Racing

For English versione go here Il progetto open source LibrePilot è stato fondato nel luglio 2015. Esso si concentra sulla... Continua »

Eachine Racer 250: flashing CC3D to LibrePilot firmware

There are the PID used during the migration to LibrePilot with the Eachine Racer 250. First test with ZMR suggested... Continua »